Default Gateway Not Available During Netgear Extender Setup

No internet connectivity can be a headache for all of us, especially in the on-going pandemic. Isn’t it? One common yet major problem that 4 out of 5 users report during Netgear range ext setup is the default gateway not available. Alas! Well, the default gateway not available problem might prevent you from accessing the internet. Hence, it is important to know the solution to solve the issue.

Default Gateway Not Available During Netgear Extender Setup

The cause behind the default gateway is not available during Netgear extender setup is incorrect or wrongly entered the IP or the web address. So, to fix the issue, make sure to entered Netgear extender IP address or the web address correctly without typos.

Apart from this, make sure that you aren’t using the web address search bar for entering the web or the IP address.

Fix: Default Gateway Not Available During Netgear Extender Setup

Install New Ethernet Driver Prior to Setting up Netgear Extender

On the off chance you are facing this error in your OS (operating system) prior to setting up Netgear extender with your PC or laptop, consider updating your Ethernet driver. To do so, visit your PC’s or laptop’s website.

Once the latest version of Ethernet driver gets downloaded, connect your Netgear WiFi range extender and try to visit mywifiext net to check whether the default gateway problem has been fixed or not.

If the problem has been fixed and the Netgear WiFi extender setup is done successfully, update its firmware in order to get the most out of it. The latest version of Netgear extender firmware helps in keeping your device’s performance up-to-date, enhance security, and add the latest new features.

Change your Router’s Frequency before the Netgear WiFi Range Extender Setup

At times, the default gateway issue persists because of the wireless frequency on your router. Change the wireless frequency of your router in order to fix the “default gateway not available during Netgear WiFi range extender setup” issue.

Reboot Your Netgear WiFi Extender and the Router

Rebooting your Netgear WiFi extender and the router and can fix many big bugs including the “default gateway not available during Netgear extender setup” issue. To do so, simply turn off your router and the Netgear extender. Wait for a few minutes and turn them back on again. You can reboot your PC or laptop as well using the same method.

Connect your Router to the Netgear Extender

To solve the issue, it is important to connect your router to the Netgear extender using an Ethernet cable. Besides, you can also connect your extender to the router using a WiFi connection. Simply connect your extender to the router’s WiFi network. But beware! Do not get connected to an unknown network.

Setup Your Extender Properly

Reconfigure your Netgear WiFi range extender. See if it is the cause behind the issue. To setup Netgear extender again, follow the steps given below.

  • Power on your Netgear extender.
  • Open a web browser on your computer or laptop.
  • Connect to Netgear_ext.
  • Take your mouse cursor to the browser’s address bat and click on it.
  • Type or in the address bar only.
  • Netgear Genie setup page displays.
  • Follow the instructions and without any hassle, reconfigure your device.

Bonus Tip: Use the command prompt to know about the default gateway.

If the “default gateway not available during Netgear range ext setup” issue continues to trouble you, then the only way to get rid of it is to reset your device. For this, simply grab a thin object – insert it into the Netgear extender reset hole – hold it for a short while and release it after that. Now everything is reset back to the factory default values be it your extender’s SSID, password, Genie setup settings, gateway, security, configuration, etc.

Write a Reply or Comment

Your email address will not be published. Required fields are marked *